Knife Maker's Center LineScribe Kit Manufactured in 304

This centerline marker kit is 100% complete This scriber uses 2 bearings. Body changed from 1/2" X 1/2" square steel to 13MM×13MM stainless steel, approximately 2-1/2" long. The kit includes a steel body, 2 bearings, 2 washers , 1 Aluminum Thumb Screw and 1 Well - Grind Sharp Carbide Rod. Bearings are about 0.282 (9/32") apart when assembled, so this can easily scratch 1/4" stock .Steel body is fully finished. No drilling or threading required. This unit will score any thickness from zero to 1/4" thick. You rotate the scriber on the workpiece until the bearings touch each side. This is an egocentric design. Tungsten carbide rods are approximately 1-1/2" long and 1/8" in diameter. One end is slightly chamfered, and the other end is professionally ground to a 60-degree acute angle

• This centerline marker kit is 100% complete This scriber uses 2 bearings. The body is made of 13MM×13MMstainless steel and is approximately 2-1/2" long. The kit includes a steel body, 2 bearings, 2 washers, 1 aluminum alloy thumbscrews, and 1 Sharp carbide rods are ground for each hole.
• This scribe uses 2 bearings. The main body is made of 1/2" X 1/2" square steel and is about 2-1/2" long. The kit includes a steel body, 2 bearings, 2 washers, 1 aluminum alloy thumbscrew, and 1 well-ground sharp carbide rod.
• The spacing between the bearings when assembled is about 0.282 (9/32"), so this can easily scratch the 1/4" stock. The steel body is completely finished. No drilling or threading is required. The device will scribe any thickness from zero to 1/4" thick. You rotate the scribe on the workpiece until the bearings touch each side. This is a self-centering design.
• The tungsten carbide rod is about 1-1/2" long and about 1/8" in diameter.Manuf Manufactured in 304
• One end has a slight chamfer, and the other end is professionally ground to an acute angle of 60 degrees